- This topic has 0 replies, 1 voice, and was last updated 4 years, 8 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
These are used by putting a piece of aluminum foil between them and then pressing to create scale corrugated sheet in O, HO and N. I have had them printed in O and HO so far and they worked but ….
These dies are small. To make them easier to use I glued one die to a piece of wood to give a firm base and glued another pice of wood to the other die as a handle. Simple but effective –
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.