18″ Grab Iron Jig


These adapters are printed in PLA and will accept the appropriate sized Bell End Concrete Pipe. I suspect that these along with the other drainage parts will be used for display purposes so fitting is secondary .. although they do fit correctly.

Available on backorder




I created a jig to bend the wire to fit the hole spacing (18″ Full-Size) of the holes printed in the base (and other units). To use the jig you cut off a length of 22 AWG wire, bend into a U-shape, insert the ends of the wire into the holes in the Jig then squeeze and press until the wire conforms to the shape. Remove the wire, cut off excess length and you are ready to install the Grab Irons.

Additional information

Bell End Adapter Size

15", 18", 24", 30"


There are no reviews yet.

Be the first to review “18″ Grab Iron Jig”

Your email address will not be published. Required fields are marked *

Modeling Scales

Please check the scales you model