Bottle Stabilizer – Bob Smith Industries Un-Cure – 1oz/28g – Digital Download

$0.00

This stabilizer was designed for a 1.4″ / 35.6mm x .935″ /23.8mm oval bottle and will only hold a bottle this size or smaller. I would imagine that the bottle used by BSI can change at any time.

Modeling Scales

Please check the scales you model

Category:
 

Description

Overview

We have all done it .. bump into a liquid cement bottle, a super glue activator, paint etc. and the bottle spills the contents across our work table resulting in a mess, wasted $ and use of NSFW language. An object with a lower center of mass is typically more difficult to tip over but for the purpose of this discussion “stability is directly proportional to the area of the base on which the body rests“. To that end I created these holders that increase the area of the base to help limit tipping over the bottles. Obviously you CAN still tip them over .. just not as easily.

Bob Smith Industries Debonder .. Un-Cure – 1oz/28g – Digital Download of STL file

This stabilizer was made to hold a Bob Smith Industries Un-Cure – 1 0z/ 28 g bottle of CA Glue Remover has a 5-10 sec working time. I added a “wart” to one side to hold the applicator tip that comes with the Un-Cure bottle.
Safe Harbor Statement: This oval bottle is 1.4″ / 35.6mm x .935″ /23.8mm so this stabilizer will only hold a bottle this size or smaller. I would imagine that for small product runs this can change at any time.

Reviews

There are no reviews yet.

Be the first to review “Bottle Stabilizer – Bob Smith Industries Un-Cure – 1oz/28g – Digital Download”

Your email address will not be published.